Thids adds a uefi_load <block dev name> command, which will
parse the PE header and do some basic validation checks.
Bug: 294283461
Test: uefi_load virtio0
Change-Id: I97393652526bda5be1b995e59647e239c64d31d6
Some routines inside the sensor bus code in dartuino need floating
point, so put those in MODULE_FLOAT_SRCS.
Also mark app/accellerometer as needing float.
Port to the really neat 68010 based board at https://rosco-m68k.com/
Port Features:
-10Mhz 68010
-1MB ram
-Dual UART + timer implemented as a 68c681 chip
-timer running at 1Khz, UART A for console
-interrupt driven RX support
Some amount of extending of the 68k exceptinon code was needed to
support the autovectored irqs that the 68681 uart uses. Added build
system support for 68010.
Uses the QEMU virt machine for 68k defined in qemu 6.0+.
Basic support that boots, prints to the console, takes input from
console, and context switches.
TODO: interrupt support, timer support.
- just a skeleton to get us started
- cpu feature config and irq names / vectab2 setup done
- pulled in the second stage for pico as a blob for now
- seems to be hard faulting out of systick setup in platform_init()
Previous to now it had always relied on a custom patched gcc
and a custom sim. In the interim since the initial port went in
some time in 2015 GCC and QEMU have both officially picked up support
for the architecture and the machine that was emulated in the previous
emultor.
Using gcc 10.2 fix up the build and get it basically working. Timers
seem to not be working right but it's probably fairly easy to fix.
-Fix plic driver to handle machine vs supervisor mode
-Add switch to scripts/do-qemuriscv to run in supervisor mode (with OpenSBI)
-Use the FDT to detect the number of cpus and size of memory
Most of changes were moving around where macros were defined, plus the
following:
- Remove requirement for floating point on RV64 to support booting
monitor core on U54 SoC.
- Add support for Debug LEDs on HiFive Unleashed Board
* Adds target tms570-launchpad, for TI TMS570 Launchpad Dev Kit
(https://www.ti.com/store/ti/en/p/product/?p=LAUNCHXL2-TMS57012)
* Adds CPU definitions for Cortex R4F (BE) CPU, implementing
ARMv7-R ISA. Does not yet add definitions for ARMv7 arch entry
functions.
* Board does not yet build - platform.c/uart.c are empty, no GIC
entry points provided.
Very little needed to port except to conditionalize some assembly in the
context switch and exception code. Mostly needed to move build system
stuff around and add a new project.
The virt machine is a generic target, much like the arm virt machine.
Intended to be simple to use and a good target to run large systems like
linux on. At the moment simply support booting and simple uart and timer
support.
-Add support for x86 legacy mode, designed for 386+ instead of pentium+
-Fixup uart driver to support com2
-Stub out PCI driver properly
-Fixup IDE driver to detect legacy disks
Currently targets qemu's sifive_e machine, which is a split flash/ram
machine, much like the Sifive HiFive1. Untested as of yet on a real
HiFive1.
Basic support including interrupts and architectural timers in place.
